how to test a starter on atv

It can be very difficult to tell when an ATV starter is in need of repair or replacement. Fortunately, there are a few simple tests that you can do to determine whether or not your ATV starter is working properly. Knowing how to test your ATV starter can help you save time and money, as well as keep you on the trail.

Your ATV starter is responsible for cranking the engine when you turn the key. It requires you to have strong and reliable batteries in order to ensure that it functions properly. If your ATV does not start, then the first thing you will want to do is to test the starter to make sure that it is functioning correctly. In this article, we will discuss how to test a starter on an ATV.

The first thing you will need to do is to check the battery voltage. This can be done by using a multimeter set to the “DC voltage” setting. When you measure the voltage, it should be between 12 and 14 volts. If the voltage is lower than 12 volts, then it may be time to replace the battery.

The next step is to check the solenoid. The solenoid is a small device that is connected to the starter. It is responsible for engaging the starter when the key is turned. To check the solenoid, you will need to disconnect the starter wires and use a multimeter set to “continuity” mode. Connect the multimeter probes to the terminals on the solenoid and check for continuity. If there is none, then the solenoid needs to be replaced.

Once the solenoid has been tested, you will want to check the starter. You can do this by connecting a jumper cable from the positive terminal on the battery to the positive terminal on the starter. Then, connect another jumper cable from the negative terminal of the battery to the negative terminal of the starter. Finally, turn the key to the “on” position and listen for the starter to engage. If it does not engage, then the starter needs to be replaced.

Finally, if the starter engages but still doesn’t start the engine, then you may need to check the starter relay. This is a small component that is located near the starter. To test the relay, you will need to disconnect the relay connector and use a multimeter set to “continuity” mode. Connect the multimeter probes to the terminals on the relay and check for continuity. If there is none, then the relay needs to be replaced.

By following these steps, you can quickly and easily test your ATV starter and determine if it needs to be repaired or replaced. This will save you time and money in the long run by ensuring that your ATV is always running perfectly.

Battery 101 Everything You Need To Know About Boat Or Atv Batteries